BM 2610925944 6-05 6/10/05 11:50 AM Page 15
can cause the tool to operate improperly orCleaning
damage the charger.
To avoid accidents, always
!WARNING
Long term battery storage should be indisconnect the tool and/or
the discharged state. Battery packs lastcharger from the power supply before
longer and re-charge better when they arecleaning. The tool may be cleaned most
stored discharged. Remember to fully re-effectively with compressed dry air. Always
charge battery packs before using afterwear safety goggles when cleaning tools
prolonged storage.with compressed air.
TOOL LUBRICATIONVentilation openings and switch levers must
Your Bosch tool has been properly lubricatedbe kept clean and free of foreign matter. Do
and is ready for use.not attempt to clean by inserting pointed
objects through opening.
D.C. MOTORS
The motor in your tool has been engineeredCertain cleaning agents
CAUTION!
for many hours of dependable service. Toand solvents damage
maintain peak efficiency of the motor, weplastic parts. Some of these are: gasoline,
recommend it be examined every six months.carbon tetrachloride, chlorinated cleaning
Only a genuine Bosch replacement motorsolvents, ammonia and household detergents
specially designed for your tool should bethat contain ammonia.
used.
Accessories
If an extension cord isRECOMMENDED SIZES OF EXTENSION CORDS
!WARNING
necessary, a cord with120 VOLT ALTERNATING CURRENT TOOLS
adequate size conductors that is capable2
Tool?s Cord Size in A.W.G.Wire Sizes in mm
of carrying the current necessary for your
Ampere
tool must be used. This will preventRatingCord Length in FeetCord Length in Meters
excessive voltage drop, loss of power or2550 100 15015 30 60 120
overheating. Grounded tools must use 3-wire3-6181616140.75 0.75 1.5 2.5
extension cords that have 3-prong plugs and6-8181614120.75 1.0 2.5 4.0
receptacles.8-10181614120.75 1.0 2.5 4.0
NOTE: The smaller the gauge number, the10-12161614121.0 2.5 4.0 N
heavier the cord.12-161412NNN N NN
(*= standard equipment)* Vacuum connector
(**= optional accessories)** Vacuum hose
** Chip bag
* Standard parallel width guide fence
** 15 minute charger
** Deluxe angle fence
** 30 minute charger (single bay)
** Rabbeting depth stop
** 30 minute charger (dual bay)
* Blade wrench 2.5mm
** 1 hour charger
* Carbide reversible blades (2)
-15- |