Adjustments(continued)
Disconnect plug from power source
before performing any assembly,!WARNING
adjustment or repair to avoid possible injury.
Blade Square to Fence
1. Lower head assembly and engage head assem-Fence
bly lock pin.Blade
2. Set table at the 0! miter position and tighten miter
lock knob.
3. Place combination square against fence with ruler
of square paralel to blade. Ruler should contact
blade, but not blade teeth. If blade is not square
against ruler, follow the fence alignment proce-
dure. (Figure 1)
Combination
Fence AlignmentSquare
a. Remove both fences by loosen fence knob, slide
fence to full in position, and pull up on fence.
Figure 1. Blade Square to Fence
b. The head assembly should remain in lowered
position.
c. Loosen the four (4) hex bolts behind fence using
Fence
multi purpose wrench (Figure 2).HexKnob
FenceHexBolts
d. Adjust fence until blade and fence have full con-KnobBolts
tact with the square.
e. Tighten the four (4) hex bolts.
f. Re-attach sliding fence.
Figure 2. Fence Adjustment
16. |