To check brushes: Disconnect battery packthe brushes to Oseat� properly and will give
from tool. Remove brush cover at the rear partyou more hours of life from each set of
Fig. 6brushes.
Only genuine Bosch replacement brushes
BRUSH
COVERspecially designed for your tool should be
used.
BRUSHCleaning
HOLDERTo avoid accidents, always
!WARNING
disconnect the tool and/or
charger from the power supply before
FIG. 6cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
Insert a screwdriver or similar object into the
not attempt to clean by inserting pointed
red notch of the carbon brush and lift out the
objects through opening.
brushes; note which way they face, so that the
brushes can be returned to their originalCertain cleaning agents
!
position. Clean the brush holder openings withCAUTIONand solvents damage
compressed air or a clean cloth and replaceplastic parts. Some of these are: gasoline,
the brushes and brush covers.carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
After replacing brushes the tool should be run
that contain ammonia.
at no-load and run it freely at full speed for 2
minutes before using the tool. This will allow
Accessories
If an extension cord isRECOMMENDED SIZES OF EXTENSION CORDS
!WARNING
necessary, a cord with120 VOLT ALTERNATING CURRENT TOOLS
adequate size conductors that is capable
ToolOs Cord Size in A.W.G.Wire Sizes in mm2
of carrying the current necessary for your
Ampere
tool must be used. This will preventCord Length in FeetCord Length in Meters
Rating
excessive voltage drop, loss of power or2550 100 15015 30 60 120
overheating. Grounded tools must use 3-3-6181616140.75 0.75 1.5 2.5
wire extension cords that have 3-prong plugs6-8181614120.75 1.0 2.5 4.0
and receptacles.8-10181614120.75 1.0 2.5 4.0
NOTE: The smaller the gauge number, the10-12161614121.0 2.5 4.0 N
heavier the cord.12-161412NNN N NN
* Screwdriver bit* = standard equipment
* Carrying case** = optional accessories
** Tether hook
-13- |