BM 1609929J64 12-05 12/12/05 4:07 PM Page 7
Assembly
WHEEL GUARD INSTALLATIONTO REMOVE GUARD: Depress release button,
Wheel guard must berotate guard until arrow on guard lines up with
attached when using discarrow on spindle neck, and remove guard from!WARNING
grinding wheels. Always keep wheel guardspindle neck.
between you and your work while grinding.
FIG. 2
The position of the guard can be adjusted to
accommodate the operation being performed.
To attach wheel guard DISCONNECT tool
from power source.
Position wheel guard on spindle neck so that
the arrow on guard lines up with the arrow on
the spindle neck. Rotate wheel guard
Fig. 2
TO ADJUST GUARD: depress guard release
Fig. 1WHEELSPINDLE
release button and let it click in place.GUARDNECK
LOCK NUT AND BACKING FLANGESIDE HANDLE
Your tool is equipped with a threaded spindleThe side handle used to guide and balance the
for mounting accessories. Always use thetool can be threaded into the front housing on
and backing flangeeither side of the tool, depending on personal
has same thread size as spindle.preference and comfort. Use the side handle
for safe control and ease of operation.
Disc Grinding Wheel AssemblyFIG. 3
Models 1800, 1801 & 1803EVS only
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Place BACKING FLANGE and GRINDING
WHEEL on the spindle. Thread on the lock
nut and tighten nut using the supplied lockSPINDLE
nut wrench, while holding the spindle lock in
Fig. 3
WHEEL
GUARD
SPINDLE
GRINDINGBACKING
FLANGEWHEEL
BACKING
FLANGE
GRINDING
WHEEL
LOCK NUT
LOCK NUT
-7- |