BM 1609929J64 12-05 12/12/05 4:07 PM Page 9
Sanding Accessories Assemblybrushes are equipped with their own
threaded hub, simply thread on to spindle
BACKING PAD
(Fig. 6). Be sure to seat against shoulder
Before attaching a backing
!pad be sure its maximumWARNINGbefore turning tool OON�.
safe operating speed is not exceeded by the
nameplate speed of the tool.FIG. 6
Wheel guard may not be
!WARNING
used for most sanding
operations. Always reinstall wheel guard
when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Set the
SPINDLE
spindle up
rubber backing pad onto the spindle shaft.
Center the sanding disc on top of the
backing pad. Insert the lock nut through the
BACKING
disc and thread onto the spindle as far as
PAD
you can with your fingers. Press in the
spindle lock, then tighten the backing pad
Fig. 6
TO REMOVE BACKING PAD ANDSANDING
DISC
SANDING DISC
Disconnect tool from power source. Using
the lock nut wrench unscrew the nut from the
LOCK NUT
spindle, while holding spindle lock in.
WIRE BRUSH ASSEMBLY
WIRE
Before assembling wire brush to this tool,BRUSH
disconnect from the power source. Wire
Operating Instructions
SLIDE ON-OFF SWITCH WITH LOCKTO UNLOCK THE SWITCH, simply press
The tool is switched OON� by the switchand release the REAR portion of the button.
button located at the side of the motorSwitch is spring loaded and will snap back
housing. The switch can be locked in theautomatically.
OON� position, a convenience for long
Hold the tool with both hands
grinding operations.!WARNING
while starting the tool, since
TO TURN THE TOOL OON� without locking it,torque from the motor can cause the tool to twist.
slide the switch button forward by applying
Start the tool before applying to work and let
pressure ONLY at the REAR portion of the
the tool come to full speed before contacting
button. When pressure is released the switch
the workpiece. Lift the tool from the work
button will snap to OOFF� position.
before releasing the switch. DO NOT turn the
TO LOCK THE SWITCH OON�, slide theswitch OON� and OOFF� while the tool is
switch button forward and press OIN� theunder load; this will greatly decrease the
FRONT portion.switch life.
-9- |