BM 1609929C33 10/03 10/28/03 2:49 PM Page 7
Assembly
WHEEL GUARD INSTALLATIONTO REMOVE GUARD: Open guard release/lock
Use wheel guard with disclatch, rotate guard until the two bumps on
!WARNING
grinding wheels. Alwaysguard line up with the two notches on the
close the latch to secure the guard. Keep thespindle neck, and lift guard off the spindle
guard between you and the wheel. Do notneck.
direct guard opening toward your body.
The position of the guard can be adjusted toNOTCHES
accommodate the operation being performed.
SPINDLE
To attach wheel guard DISCONNECT toolNECK
NOTCHES
from power source.
WHEEL
Open guard release/lock latch and positionGUARD
guard on spindle neck so that the two bumps
on guard, line up with the two notches on the
spindle neck.
Rotate guard either direction to desired
GUARDBUMPS
position, and close latch to secure guard inRELEASE / LOCK
place.LATCH
LOCK NUT AND BACKING FLANGESIDE HANDLE
Your tool is equipped with a threadedThe side handle used to guide and balance
spindle for mounting accessories. Alwaysthe tool can be threaded into the front housing
use the supplied lock nut (and backingon either side of the tool, depending on per-
flange) that has same thread size as spindle.sonal preference and comfort. Use the side
handle for safe control and ease of operation.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Place BACKING FLANGE and GRINDING
WHEEL on the spindle. Thread on the lock
nut and tighten nut using the supplied lock
nut wrench, while holding the spindle lock in.
TO REMOVE: Reverse procedure.
SPINDLE
SPINDLE
WHEEL GUARD
GRINDING
WHEEL
BACKING
FLANGEBACKING FLANGE
GRINDING WHEEL
LOCK NUT
LOCK NUT
-7- |