BM 2610909797 6/00 7/14/00 8:39 AM Page 3
Do not force tool. Use the correct tool foroperation. If damaged, have the tool
your application. The correct tool will do theserviced before using. Many accidents are
job better and safer at the rate for which it iscaused by poorly maintained tools. Develop a
designed.periodic maintenance schedule for your tool.
Do not use tool if switch does not turn itUse only accessories that are recom-
OON� or OOFF�. Any tool that cannot bemended by the manufacturer for your
controlled with the switch is dangerous andmodel. Accessories that may be suitable for
must be repaired.one tool, may become hazardous when used
on another tool.
Disconnect the plug from the power source
before making any adjustments, changing
Service
accessories, or storing the tool. Such
preventive safety measures reduce the risk ofTool service must be performed only by
qualified repair personnel. Service or
starting the tool accidentally.
maintenance performed by unqualified
Store idle tools out of reach of children andpersonnel could result in a risk of injury. For
other untrained persons. Tools areexample: internal wires may be misplaced or
dangerous in the hands of untrained users.pinched, safety guard return springs may be
Maintain tools with care. Keep cutting toolsimproperly mounted.
sharp and clean. Properly maintained tools,When servicing a tool, use only identical
with sharp cutting edges are less likely to bindreplacement parts. Follow instructions in
and are easier to control. Any alteration orthe Maintenance section of this manual.
modification is a misuse and may result in aUse of unauthorized parts or failure to follow
dangerous condition.Maintenance Instructions may create a risk of
Check for misalignment or binding ofelectric shock or injury. Certain cleaning
moving parts, breakage of parts, and anyagents such as gasoline, carbon tetrachloride,
other condition that may affect the toolsammonia, etc. may damage plastic parts.
Safety Rules for Circular Saws
Keep hands away fromCheck lower guard for proper closing before!DANGER
cutting area and blade.each use. Do not operate saw if lower guard
Keep your second hand on auxiliary handle,does not move freely and close instantly.
or motor housing. If both hands are holdingNever clamp or tie the lower guard into the
the saw, they cannot be cut by the blade. Holdopen position. If saw is accidentally dropped,
the saw firmly to prevent loss of control. Figureslower guard may be bent. Raise the lower
in this manual illustrate typical hand support ofguard only with the Retracting Handle or Lower
the saw. NEVER place your hand behind theGuard Lift Lever and make sure it moves freely
saw blade since kickback could cause the sawand does not touch the blade or any other part,
to jump backwards over your hand.in all angles and depths of cut.
Keep your body positioned to either side ofCheck the operation of the lower guard
the saw blade, but not in line with the sawspring. If the guard and the spring are not
blade. KICKBACK could cause the saw tooperating properly, they must be serviced
jump backwards. (See OCauses and Operatorbefore use. Lower guard may operate
Prevention of Kickback.�)sluggishly due to damaged parts, gummy
deposits, or a buildup of debris. Disconnect the
Do not reach underneath the work. The
guard cannot protect you from the blade belowplug from power source. Periodically remove
the blade, clean the upper, lower guards and
the work. Do not attempt to remove cut
material when blade is moving.the hub area with kerosene and wipe it dry, or
blow it clean with compressed air.
-3- |
ACEC
