BM 2610908996 6-04 6/21/04 4:47 PM Page 9
REMOVING MOTOR FROM BASE 2. Line up the arrow on the base with arrow
To remove motor from non-plunge bases:Fig. 8
Fig. 6YTo position switch on the right side of the
1. Hold router in horizontal position, openbase, line up the baseOs arrow with
base clamp lever, depress coarsearrow on the motor housing that is
adjustment lever, and pull motor upwardsbelow the cord.
until it stops.
FIG. 6
2. Turn motor counter-clockwise, and gentlyCOARSE
pull it free of base. ADJUSTMENT
LEVER
Fig. 7
1. Hold router in horizontal position, open
base clamp lever, and pull motor upwards
until it stops.
2. Turn motor counter-clockwise, and gently
pull it free of base.
INSTALLING MOTOR IN BASE
The motor can be installed with the switch
positioned on the right or left of the base from
the operator's side (and the cord facing theBASE
opposite side of the router). Install the motorCLAMP
LEVER
so that the switch is in the location you find to
be the most easily accessible from the
handles. The switch should be easier to turn
"OFF" than "ON" in case of an emergency.
To install motor in non-plunge base:
BASE
1. Release the base clamp lever.FIG. 7
CLAMP
2. Line up the arrow on the base with arrowLEVER
Fig. 8
YTo position switch on the right side of the
base, line up the baseOs arrow with
motor housingOs arrow that is below the
cord.
YTo position switch on the left, line up the
baseOs arrow with motor housingOs arrow
that is below the switch.
3. While pressing the coarse adjustment
lever, slide motor into base until resistance
in felt. (The baseOs guide pin is now
engaged into slot on motor.)
4. Continue to press coarse adjustment lever,
and turn the motor clockwise until it stops.
5. Push the motor into the base until it
MOTOR
reaches the approximate desired depth.
6. Release the coarse adjustment lever and
slide the motor forward or back as neededFIG. 8
until the coarse adjustment systemOsCOARSE
ADJUSTMENT
Ocatch� springs into the coarse adjustment
NOTCHES
detent notch.
7. Set final height position as describedALIGNMENT
below in OOperating Instructions�.ARROWS
To install motor in plunge base:
1. Release the base clamp lever.
BASE
-9- |