BM 2610943371 07-06.qxp 7/24/06 9:03 AM Page 17
Maintenance
Serviceshould be replaced at Bosch Factory Service
Preventive maintenanceCenter or Authorized Bosch Service Station.
!WARNING
performed by unauthorizedBearings which become noisy (due to heavy
personnel may result in misplacing ofload or very abrasive material cutting) should
internal wires and components whichbe replaced at once to avoid overheating or
could cause serious hazard. Wemotor failure.
recommend that all tool service be performedCleaning
by a Bosch Factory Service Center or Autho-
To avoid accidents always
rized Bosch Service Station.!WARNING
disconnect the tool from
TOOL LUBRICATIONthe power supply before cleaning or
Your Bosch tool has been properly lubricatedperforming any maintenance. The tool may
and is ready to use. It is recommended thatbe cleaned most effectively with compressed
tools with gears be regreased with a specialdry air. Always wear safety goggles when
gear lubricant at every brush change.cleaning tools with compressed air.
Ventilation openings and switch levers must
CARBON BRUSHES
be kept clean and free of foreign matter. Do
The brushes and commutator in your tool
not attempt to clean by inserting pointed
have been engineered for many hours of
objects through openings.
dependable service. To maintain peak
efficiency of the motor, we recommend everyCertain cleaning agents
!CAUTION
two to six months the brushes be examined.and solvents damage
Only genuine Bosch replacement brushesplastic parts. Some of these are: gasoline,
specially designed for your tool should becarbon tetrachloride, chlorinated cleaning
used.solvents, ammonia and household detergents
that contain ammonia.
BEARINGS
After about 300-400 hours of operation, or at
every second brush change, the bearings
Accessories
If an extension cord isRECOMMENDED SIZES OF EXTENSION CORDS
WARNING!
necessary, a cord with120 VOLT ALTERNATING CURRENT TOOLS
adequate size conductors that is capable
Cord Size in A.W.G.Wire Sizes in mm2
of carrying the current necessary for yourToolOs
Ampere
tool must be used. This will preventCord Length in FeetCord Length in Meters
Rating
excessive voltage drop, loss of power or2550 100 15015 30 60 120
overheating. Grounded tools must use 3-wire3-6181616140.75 0.75 1.5 2.5
extension cords that have 3-prong plugs and
6-8181614120.75 1.0 2.5 4.0
receptacles.8-10181614120.75 1.0 2.5 4.0
NOTE: The smaller the gauge number, the10-12161614121.0 2.5 4.0 N
12-16
heavier the cord.1412NNN N NN
1/4� Collet Chuck *Dust Extraction Hood Templet Guide Adapter *
1/2� Collet Chuck *for Edge Forming **Templet Guides **
24 mm Collet Nut Wrench *Adapter for Various Centering Cone **
3/8� Collet Chuck **Vacuum Hoses *Router Table **
8 mm Collet Chuck **Vacuum Hose **
Dust Extraction Hood * Deluxe Router Guide ***= standard equipment
Router Bits ****= optional accessories
-17- |